I cant seem to get the RLCA to match up to the brackets. Suggestions?

I'll let Billy answer your question, but it might be covered in this very long, very informative thread: http://www.rx7club.com/showthread.php?t=71...;highlight=rack

Best of luck.

One thing to note is to install the RLCA in the bracket and the use the 3/8" bracket and clevis to pull it into place.

If the angle seems off make sure the left hand RLCA is being used on the left hand side.

With the pivot point installed into the bracket you will notice the
bent tube will either angle down or up. Both the driver side and
passenger side should angle up. If they angle down you need to flip
sides.

This image is not the best because you are looking angled down at the
RCLA. But imagine if you were looking straight on it.

-billy


Click to view attachment