Billy,
Will the strut tower brace with firewall bracing fit on a first gen with Weber carb?

TKS!
Don Hartman

Depends on the air cleaner. You can check with a broom handle or piece of material. Put one end near the top bolt for the hood latch on the fire wall the other end will go to the strut mount bolt that is closest to the firewall and engine. This will tell you where the bar will run once installed.

-billy

I only had to trim about 2 inches off the edge of the top section of my RB Stock carb filter kit to clear the firewall brace. It's much larger than the 2bbl carb filter assemblies so you should be fine.