 rack and pinion RLCA issues |
  |
 Jun 17 2010, 08:01 PM
Post
#1
|
|
|
Newbie  Group: Members Posts: 1 Joined: 9-November 09 Member No.: 779  |
I cant seem to get the RLCA to match up to the brackets. Suggestions?
|
 |
 
|
|
Jun 18 2010, 12:02 AM
Post
#2
|
|
|
Advanced Member Group: Members Posts: 110 Joined: 31-May 07 Member No.: 16 |
I'll let Billy answer your question, but it might be covered in this very long, very informative thread: http://www.rx7club.com/showthread.php?t=71...;highlight=rack
Best of luck. 
-------------------- "Learn from the past, or it will become your future...."
'85 GS 12a + LSD/Sterling carb/Respeed coilovers/Respeed front swaybar/Respeed adj. rear spring perches/Illuminas/Bilsteins on rear AutoX vids @ http://www.youtube.com/user/Kentetsu1 |
|
|
|
|
Jun 18 2010, 06:12 PM
Post
#3
|
|
|
Advanced Member Group: Root Admin Posts: 143 Joined: 14-May 07 Member No.: 2 |
QUOTE (singleslammer @ Jun 17 2010, 08:01 PM)  I cant seem to get the RLCA to match up to the brackets. Suggestions? One thing to note is to install the RLCA in the bracket and the use the 3/8" bracket and clevis to pull it into place. If the angle seems off make sure the left hand RLCA is being used on the left hand side. With the pivot point installed into the bracket you will notice the bent tube will either angle down or up. Both the driver side and passenger side should angle up. If they angle down you need to flip sides. This image is not the best because you are looking angled down at the RCLA. But imagine if you were looking straight on it. -billy 
DCFC0017.JPG ( 78.17K )
Number of downloads: 12 |
|
|
|
|
|
Lo-Fi Version | Time is now: 9th September 2010 - 05:19 AM |